Date | Target | Correction |
---|---|---|
2018.03.14 | page 110, caption of picture 205 is in Finnish. | Dimensions that optimise risk and benefits of overhead ladders. |
2018.03.20 | page 122, caption of picture 229 is in Finnish. | An example of a traditional swing with 2 seats. |
2018.03.20 | page 123, caption of picture 230 is in Finnish. | An example of a traditional swing with more than 2 seats. |
2018.03.20 | page 123, caption of picture 231 is in Finnish. | An example of group swing with a single support point. |
2018.03.20 | page 123, caption of picture 232 is in Finnish. | An example of group swing with 2 support points. |
2018.03.20 | page 123, caption of picture 233 is in Finnish. | An example of a contact swing. |
2018.03.20 | page 123, caption of picture 234 is in Finnish. | An example of a swing attached to another item of equipment. |
2018.05.14 | page 053, new indent before the first | Goals weighing 10 - 18 kg are tested with a force equal to 30 kg mass. |
2018.06.17 | page 227, fourth last indent under paragraph 3 is real paragraph | In addition to... - An inspector is... - The risk level... |
2018.06.17 | page 179, lower table, fourth last row, second column is in Finnish | - Risk taking - Challenging climbing activities - A slide over 2200 mm high |
2018.07.17 | page 175, paragraph 129, first indent | The table size is 2740 mm x 1525 mm. |
2018.07.18 | page 027, paragraph 11 | Inspector The Inspector carrying out the post installation inspection... |
2018.08.13 | page 120, paragraph 3 starting "Adventure playgrounds..." together with three indents after that should be indents under paragraph 2. | EN 1176 is not applicable to: - Adventure playgrounds which are… - Play equipment connected to water. - Toys for domestic use. - Play equipment connected to electricity. |
2018.08.14 | page 150, paragraphs 148 and 149 | "Paragraph 148" should be an empty row. Paragraph 149 is a sub-title for paragraphs 150 - 154. |
2018.08.14 | page 150, pictures 291 and 290 | These two pictures have swapped their places. |
2018.08.14 | page 155, paragraphs 189 - 193 | These paragraphs belong to the Case starting before paragraph 189. |
2018.09.09 | Page 314, paragraph about EN 16899 clause 4.2.5. | Remove "4.2.5" since this line and following three lines should refer to 5.3. |
2018.09.09 | Page 315, paragraph about EN 16899 clause 4.4.8. | Instead of "4.8.4." should be "5.8.4." |
2018.09.11 | Page 137, Tip under chapter "Moving parts" | ...bringing 70 kg mass to the playground is not feasible. |
2018.10.08 | Page 173, paragraph 115 | ...measured without applying pressure to the measuring device. |
2019.01.29 | Page 169, paragraph 75, fourth indent | Bar or rail … minimum step size is 700 mm. |
2019.04.30 | Page 128, caption of picture 242 | c > a + 0.05 x b |
2019.04.30 | Page 133, table "The difference between types 1 and 2", first column, last row is in Finnish. | Extent of safety area |
2019.04.30 | Page 90, paragraph 107, first indent | Bouncing facility: 1500 mm |
2019.04.30 | Page 91, paragraph 108, first sub-indent under the fifth indent | Cable-way: always at least 1000 mm - For seating type: the seat height |
2019.05.13 | Page 107, paragraph 17 | |
2019.05.13 | Page 140, caption of picture 337 | >1800 mm |
2019.05.13 | Page 212, table | > > 30 - > 5 - < 5 % |
2019.06.26 | Page 006, EN 1176-10 and EN 1176-11 | Both standards were published in 2008, not in 1998. |
2019.06.28 | Page 90, paragraph 107, first indent | Bouncing facility: |
2019.07.15 | Page 159, paragraph 27, first indent | Stainless steel cannot be used as grinding surfaces. |
2019.07.17 | Page 222, paragraph 03 third indent | ...their barriers will be higher than 700 mm. |
2019.07.22 | Page 303, ref 4.2.16.1, 9th part | The ground clearance for a <1.44 m2 bouncing facility is 100 |
2019.07.22 | Page 303, ref 4.2.16.1, 10th part | The ground clearance for a ≥1.44 m2 bouncing facility is 230 |
2020.09.13 | Page 080, paragraph 50 | ...is inclined at less than |
2022,04,28 | Page 215, after paragraph 15 | Added new paragraph: "There is less need for running detterent at the ends of the safety area. If a fence is located there for any reason, it should be positioned at least 1000 mm from the safety area." |